CTP / Application Engineering Reference

Mini Microphone Magnetic Cable Engineering Example

A compact microphone interface may need charging together with detection, control or selected data functions. Six contacts provide positions that can be allocated by an approved pin map; the count does not define a protocol, data rate or audio performance. Start with the microphone electronics and enclosure rather than assuming a cable is compatible from its appearance.

Engineering reference only. No documented customer deployment, first-hand test report or approved application drawing is claimed on this page. Final custom values follow the agreed customer specification.

CTP 6 Pin Round Magnetic Charging Cable with USB-A — physical hardware reference — Existing six-contact round cable product photograph. It is a hardware configuration reference, not evidence of a microphone deployment or data-speed test.

Allocate each electrical function

Specify supply, return and the purpose of every additional contact. State whether the interface carries analog signals, a digital protocol, identification or only charging. Review return paths, shielding, wire construction and cable length with the device electronics. This page does not promise high-speed data, noise-free audio or compatibility with an unspecified protocol.

Check the docking envelope

Provide the available diameter, recess depth, device-side contact geometry and cable exit direction. Magnetic alignment, polarity and mechanical guidance must be considered together. Prevent unintended electrical combinations during reversed or partial mating through the approved interface design rather than relying on a magnet-grade label.

Plan sample evaluation

Agree charging conditions, functional signal checks, movement during use and cable pull or flex conditions. Review contamination and the required cleaning method for portable audio equipment. Electrical and mechanical acceptance must be defined for the finished assembly; the catalog image is not a measured reliability result.

Information to Send for Engineering Review

Send the full six-contact pin map and the electronics interface requirements.
Define cable length, exit angle, shielding and device-side installation space.
Describe charging conditions and how the microphone is used while connected.
Agree functional, mating and cable-mechanics checks for project samples.

Related Hardware and Next Steps

Email: bella@ytanpogo.com